Fix the Rear Leg and the Front Cross Member with the spacer and the Hex Bolt of UNC3/8x4″b=30. Then fix the Rear Cross Member with Stand Stop Assembly to the Rear Leg with the spacer and the Hex Bolt of UNC3/8x4″b=30 as well. Then fix the Front Leg in the same way.

 Firstly, Fix the Axle to the Front Leg with the Lock Nut and the Lock Washer as the above picture shows. Put the wheel to the Axle, put the washer and then lock the wheel with the Cotter Pin. Then, lock the other wheel in the same way.

  Put in the Handle to the Front Leg as the above picture shows. Lock the Handle with the Lock Nut and the Hex Bolt. Then install the other handle in the same way. Put in the End Cap to the handle at last.

 Put the tray into the cart as in the above picture. Aligning the corresponding holes and then put in the Flat Washer, then lock with the Hex Bolt. Lock all the four bolts in the same way.

Fix the Hex Bolt of UNC3/8x2 3/4″b=30 to the right end hole of the Rear Leg as the above picture shows. Fix the Washer of 1/4 together with the Hex Bolt of UNC1/4x50 b=27 to the third hole from the right end of the Rear Leg as the above picture shows. Then put the Washer of 5/16 together with the Hex Bolt of UNC5/16x56 b=30 to the fourth hole from the right end and fix by the Hex Nut of 5/16. Fix the left end holes and bolts of the Rear Leg in the same way as the picture shows. And also fix the holes and bolts(specifications same with the ones on the Rear Leg) of the Front Leg in the same way. After fixing all the bolts in both the Rear Leg and the Front Leg, install the Leveling Pad to the right end of both the legs as the picture shows above. Then the installation of 672 stand is finished.

After 672A stand installation, put on the machine to the Cross Member and fix the bolt.